XF 2.3 Active state not showing one only one navigation tab

[ECH]

My site (https://paranormal.community.forum/), which is still in development, has several navigation tabs that, when selected, display a category page. Each navigation tab is setup exactly the same, however one tab (UFO) does not show its active state. The navigation tab UFO will show its hover state, but will not show its active state. I would so very much appreciate help from anyone who has any ideas as to why this is happening? I am at my wits end trying to figure this out.

tab UFO --> Category node: UFO, UAP, and Aerial Phenomena
tab Ghosts --> Category node: Ghosts and Apparitions
tab EVP --> Category node: Electronic Voice Phenomena (EVP) and ITC

Nodes:
UFO, UAP, and Aerial Pheonomena [Category]
UFO - Personal Experience [Forum]
UFO - Discussion and Research [Forum]
...
Ghosts and Apparitions [Category]
Ghosts - Personal Experience [Forum]
Ghosts - Discussion and Research [Forum]
...
Electronic Voice Phenomena (EVP) and ITC [Category]
EVP - Personal Experience [Forum]
EVP - Discussion and Research [Forum]
...

The menu is setup as follows:
UFO:
Navigation ID: UFO
Title: UFO
Type: Node
Node: UFO, UAP, and Aerial Phenomena
Ghosts:
Navigation ID: Ghosts
Title: Ghosts
Type: Node
Node: Ghosts and Apparitions
EVP:
Navigation ID: EVP
Title: EVP
Type: Node
Node: Electronic Voice Phenomena (EVP) and ITC

 

[Blatchy]

check that navigation id is in route context.

 

[ECH]

That did it. Thank you so very much.